{"id":627,"date":"2015-05-31T13:12:18","date_gmt":"2015-05-31T11:12:18","guid":{"rendered":"http:\/\/www.henningandersen.com\/?p=627"},"modified":"2015-07-06T22:01:05","modified_gmt":"2015-07-06T20:01:05","slug":"rebuilding-my-cyclone-part-2","status":"publish","type":"post","link":"https:\/\/www.henningandersen.com\/?p=627","title":{"rendered":"Rebuilding my cyclone – part 2"},"content":{"rendered":"

If you missed the first post, please find it here<\/a>.<\/p>\n

Assembling my cyclone<\/h3>\n

After milling and gluing the parts for my new cyclone I’m ready for assembling it. The plastic bottle is cut to the right length and I’ve milled a block that will fit both the bottleneck and the lid of a jar I’m planning to use for collecting the dust.<\/p>\n

\"Parts<\/a>
Parts for my new cyclone.<\/figcaption><\/figure>\n

First I install the pipes in the top part of the cyclone. I’ve taken extra care to make every hole a snug fit so no glue is required. Both the vortex finder and the inlet pipe are 32 mm plastic pipes.<\/p>\n

\"Top<\/a>
Top of cyclone with pipes installed.<\/figcaption><\/figure>\n

As you see in the photo there is a recess for the bottle itself (bottle not installed yet). Again it’s a precise fit so no glue is required.<\/p>\n

Test run<\/h3>\n

Here is a short video of my test run:<\/p>\n